A table saw fence must run parallel to the blade, or the saw becomes harder to control and less accurate. A fence that points toward the blade at the rear can pinch the workpiece, cause burning, and increase kickback risk. A fence that opens too far at the rear is usually safer, but it can … Read more
The short answer The Skilsaw SPT99-11 is the better fit for repeated ripping of framing lumber, plywood, and other sheet goods when you need a portable saw that can move around a jobsite. Its larger table and generous rip capacity make it easier to support and size stock. The SawStop Jobsite Pro is the stronger … Read more
Ripping a narrow strip on a table saw is where a good push block earns its keep. A standard push stick may keep your hand away from the blade, but it often gives poor downward pressure and little control as the workpiece passes the fence. For strips under about 2 inches wide, especially on a … Read more
Quick verdict: capacity versus convenience The Bosch GTS15-10 and DeWalt DWE7491RS are portable jobsite saws with 10-inch blades, but their rip capacities put them in different lanes. Bosch lists 32½ inches to the right of the blade and 14 inches to the left. DeWalt lists 32½ inches right and 22 inches left. That extra left-side … Read more
PVC trim is softer than wood, but it can still chip, melt, or develop a ragged edge under a circular saw. The blade matters, but so do feed speed, support, and how the trim is held. For most straight cuts, a sharp, fine-tooth carbide blade is the practical choice; the right tooth count depends on … Read more
The short answer For breaking down full sheets in a small shop, a track saw is usually the more practical first purchase. You can set a sheet on foam insulation, clamp a guide, and cut without lifting the panel onto a table. That saves floor space and reduces the risk of wrestling a heavy, floppy … Read more
Short answer: the TS 75 has more depth, not magic If you routinely rip thick hardwood slabs or need to cut material thicker than about 2 inches in one pass, the Festool TS 75 is the more capable saw. Its maximum cutting depth is about 2-15/16 inches (75 mm) with the rail, compared with roughly … Read more
The main difference between a left-blade and right-blade circular saw is which side of the shoe the blade sits on. That changes how much of the cut line you can see, but it does not make one layout universally easier or more accurate. Your dominant hand, the saw’s handle position, the material, and the direction … Read more
The best choice for cutting pressure-treated 2x lumber For most homeowners and deck builders, the best cordless circular saw for pressure-treated 2x lumber is a 7-1/4-inch, 18V or 20V saw with a brushless motor, a 24-tooth carbide framing blade, and a battery of at least 5.0Ah. That setup cuts standard 1-1/2-inch-thick lumber easily and has … Read more
Quick verdict The SKILSAW SPT77WML is the better fit for repeated heavy framing if you want a worm-drive saw with a magnesium housing and are prepared to pay more for a lighter, easier-to-handle package. The Bosch CS10 is a conventional sidewinder, not a worm-drive saw. It costs less and can handle ordinary framing, but it … Read more